RoofNeck™ Installation
*Not designed for flat roof installation.
The RoofNeck is designed for added versatility. Ideal for use with DryerJack DJK477.
- Determine location for roof vent installation. If replacing an existing roof vent, use caution as ductwork may be attached.
- Cut 4-1/4” circular hole in roof deck material. Skip step if replacing an existing vent.
- RoofNeck flange may be installed from above or underneath roof deck material.
- From above roof deck, insert longer portion of collar into the hole. (Figure A)
- From below roof deck, insert shorter portion of the collar into the hole. (Figure B)
- From above roof deck, insert longer portion of collar into the hole. (Figure A)
- Ensure the “→” on flange is pointing in the downward slope direction.
- Screw flange to deck. Screw length should NOT be longer than roof deck material thickness.
- Insert end of ductwork to the inside of RoofNeck collar. Secure with foil tape and mechanical fasteners per code. Adjustable elbow or elongated smooth elbow (Dryer Ell #LT45) may be needed to account for roof pitch.
- Install roof vent per instructions.
*Disclaimer: Professional installation is recommended.